top of page
metallic color gradient background.jpg
Search

Dishwasher Not Draining? What Standing Water Is Telling You

Writer: Expo Appliance
Expo Appliance
19 minutes ago
2 min read

You open the dishwasher after a cycle and find a puddle under the bottom rack. Before ordering a pump, check where the water is sitting and when it shows up. Those two details can help narrow down whether you’re looking at a normal amount of residual water, a blockage, or a drain problem that needs service.

 

A little water under the filter can be normal

On some models, a small amount of water stays down in the recessed filter well. You may only see it when you lift out the filter. Check your owner’s manual for what’s normal on your model. Water spread across the bottom of the tub after a completed cycle deserves a closer look.

Standing water pooled across the bottom of an open stainless steel dishwasher

Illustration of standing water across the dishwasher tub floor.

 

1. Check whether the cycle finished

If the door was opened or the power went out mid-cycle, the dishwasher may still have wash water in it. Look for an error code and follow your model’s instructions for Cancel/Drain. If the tub is leaking or water is close to spilling out, stop using the dishwasher and arrange service.

 

2. Check the filter if your model has a removable one

Switch the dishwasher off and let the water cool. Follow the owner’s manual to remove and rinse the filter, then lock it back in before running the dishwasher. If you see broken glass, keep your hands out of the sump. Some filters look alike but release differently. Use our dishwasher filter guide by brand to find the right starting point.

 

3. Look for clues at the sink

A slow kitchen sink drain, water coming out of the countertop air gap, or a problem that began right after a garbage disposal replacement can point to the drain connection. A newly installed disposal can still have its dishwasher inlet plugged. If the dishwasher emptied and dirty water returned after you used the sink, mention that timing when you call. It gives us a reason to look for backflow.

 

When to call for dishwasher repair

If water still covers the tub floor after Cancel/Drain, write down any error code and note whether you heard a hum or silence during the drain step. Either sound is a clue. A technician can check for an obstruction and determine whether the pump is receiving power before recommending a replacement.

 

In Lexington, West Columbia, or the Columbia area? Contact Expo Appliance Service and have your model number, any error code, and a photo of the water level ready. Here’s where to find your model and serial number.

 

 
 
bottom of page